P0010 Honda Hr-V
Intake Camshaft Position Actuator Circuit (Bank 1) · Powertrain Code · High · Repair: Moderate
What is P0010?
The intake camshaft position actuator solenoid circuit on bank 1 has an electrical issue. Common causes include a faulty solenoid, wiring problem, or low oil pressure.
When the Honda Hr-V triggers code P0010 (intake camshaft position actuator circuit (bank 1)), it typically points to an issue in the powertrain system. This is a high severity code, so address it promptly to avoid further damage or safety concerns. Below you'll find the most common causes, symptoms, and repair options specific to the Honda Hr-V.
This repair is rated moderate, meaning some experience and specialty tools required.
Diagnostic data on this page is compiled from publicly available repair resources and technical service bulletins. Always have a qualified mechanic confirm the diagnosis before authorizing repairs on your Honda Hr-V.
Common Causes on Honda Hr-V
- Faulty VTC actuator (common Honda issue — rattle on cold start)
- Low or degraded engine oil causing sluggish VTC solenoid response
- Failed VTC oil control solenoid (OCV) stuck open or closed
- Oil passages clogged with sludge from extended drain intervals
Symptoms
- Cold start rattle lasting 1-3 seconds (VTC actuator)
- Check Engine Light on
- Rough idle when engine is cold
- Slight loss of power at low RPM
Notes for Honda Hr-V
VTC actuator cold-start rattle is extremely common on K24W and Earth Dreams engines — replacing the actuator with the updated part resolves it permanently.