P0010 Nissan Rogue
Intake Camshaft Position Actuator Circuit (Bank 1) · Powertrain Code · High · Repair: Moderate
What is P0010?
The intake camshaft position actuator solenoid circuit on bank 1 has an electrical issue. Common causes include a faulty solenoid, wiring problem, or low oil pressure.
When the Nissan Rogue triggers code P0010 (intake camshaft position actuator circuit (bank 1)), it typically points to an issue in the powertrain system. This is a high severity code, so address it promptly to avoid further damage or safety concerns. Below you'll find the most common causes, symptoms, and repair options specific to the Nissan Rogue.
This repair is rated moderate, meaning some experience and specialty tools required.
Diagnostic data on this page is compiled from publicly available repair resources and technical service bulletins. Always have a qualified mechanic confirm the diagnosis before authorizing repairs on your Nissan Rogue.
Common Causes on Nissan Rogue
- Failed intake valve timing control (VTC) solenoid on VQ or QR engine
- Degraded engine oil restricting VTC actuator oil flow
- VTC solenoid screen clogged with debris
- Wiring fault in VTC solenoid circuit
Symptoms
- Check Engine Light on
- Rough idle when cold
- Slight hesitation on acceleration
- Reduced fuel economy
Notes for Nissan Rogue
On QR25DE engines, the VTC solenoid screen clogs frequently; clean or replace the screen during solenoid service.