P0011 Chevrolet Trax
Intake Camshaft Position Timing Over-Advanced (Bank 1) · Powertrain Code · High · Repair: Moderate
What is P0011?
The intake camshaft timing on bank 1 is more advanced than the ECM commanded. Usually caused by a stuck VVT solenoid, dirty engine oil, or timing chain stretch.
When the Chevrolet Trax triggers code P0011 (intake camshaft position timing over-advanced (bank 1)), it typically points to an issue in the powertrain system. This is a high severity code, so address it promptly to avoid further damage or safety concerns. Below you'll find the most common causes, symptoms, and repair options specific to the Chevrolet Trax.
This repair is rated moderate, meaning some experience and specialty tools required.
Diagnostic data on this page is compiled from publicly available repair resources and technical service bulletins. Always have a qualified mechanic confirm the diagnosis before authorizing repairs on your Chevrolet Trax.
Common Causes on Chevrolet Trax
- VVT solenoid stuck on 1.2T or 1.3T 3-cylinder engine
- Dirty engine oil clogging VVT passages in small turbo engine
- Cam phaser actuator stuck from lack of oil flow
- Low oil pressure from turbo oil circuit restriction
Symptoms
- Rough idle with noticeable engine vibration
- Poor fuel economy from incorrect valve timing
- Engine stalling at idle or low RPM
- Hard starting especially when engine is warm
- Rattling noise from engine timing area
- Check engine light illuminated
Notes for Chevrolet Trax
Small displacement turbo engines are very sensitive to oil quality; use only GM-approved synthetic.