P0016 Chevrolet Trax
Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A) · Powertrain Code · Critical · Repair: Moderate
What is P0016?
The crankshaft and camshaft position sensors on bank 1 are out of sync. Often caused by a stretched timing chain, jumped timing, or a failed VVT solenoid.
When the Chevrolet Trax triggers code P0016 (crankshaft position - camshaft position correlation (bank 1 sensor a)), it typically points to an issue in the powertrain system. This is a critical severity code, so address it promptly to avoid further damage or safety concerns. Below you'll find the most common causes, symptoms, and repair options specific to the Chevrolet Trax.
This repair is rated moderate, meaning some experience and specialty tools required.
Diagnostic data on this page is compiled from publicly available repair resources and technical service bulletins. Always have a qualified mechanic confirm the diagnosis before authorizing repairs on your Chevrolet Trax.
Common Causes on Chevrolet Trax
- VVT solenoid stuck on 1.2T or 1.3T 3-cylinder turbo engine
- Timing chain stretch from aggressive driving or low oil conditions
- Camshaft position sensor failure from heat or vibration
- Low oil pressure from worn engine bearings at high mileage
Symptoms
- Hard starting or extended cranking before engine fires
- Rough idle with noticeable engine vibration
- Rattling or chain-slap noise on cold startup
- Reduced engine power and sluggish acceleration
- Check engine light illuminated
- Intermittent stalling at idle
Notes for Chevrolet Trax
Small turbo engines are sensitive to oil quality; always use the correct GM Dexos1 specification.