P0016 Dodge Hornet
Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A) · Powertrain Code · Critical · Repair: Moderate
What is P0016?
The crankshaft and camshaft position sensors on bank 1 are out of sync. Often caused by a stretched timing chain, jumped timing, or a failed VVT solenoid.
When the Dodge Hornet triggers code P0016 (crankshaft position - camshaft position correlation (bank 1 sensor a)), it typically points to an issue in the powertrain system. This is a critical severity code, so address it promptly to avoid further damage or safety concerns. Below you'll find the most common causes, symptoms, and repair options specific to the Dodge Hornet.
This repair is rated moderate, meaning some experience and specialty tools required.
Diagnostic data on this page is compiled from publicly available repair resources and technical service bulletins. Always have a qualified mechanic confirm the diagnosis before authorizing repairs on your Dodge Hornet.
Common Causes on Dodge Hornet
- VVT solenoid stuck on 2.0L Hurricane turbo engine
- Timing chain tensioner not maintaining proper pressure
- Camshaft position sensor connector loosened or corroded
- Low oil level from turbocharger oil seal seepage
Symptoms
- Hard starting or extended cranking before engine fires
- Rough idle with noticeable engine vibration
- Rattling or chain-slap noise on cold startup
- Reduced engine power and sluggish acceleration
- Check engine light illuminated
- Intermittent stalling at idle
Notes for Dodge Hornet
Hornet 2.0L Hurricane is relatively new; most P0016 cases are solenoid or sensor related.