P0016 Ford Bronco Sport
Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A) · Powertrain Code · Critical · Repair: Moderate
What is P0016?
The crankshaft and camshaft position sensors on bank 1 are out of sync. Often caused by a stretched timing chain, jumped timing, or a failed VVT solenoid.
When the Ford Bronco Sport triggers code P0016 (crankshaft position - camshaft position correlation (bank 1 sensor a)), it typically points to an issue in the powertrain system. This is a critical severity code, so address it promptly to avoid further damage or safety concerns. Below you'll find the most common causes, symptoms, and repair options specific to the Ford Bronco Sport.
This repair is rated moderate, meaning some experience and specialty tools required.
Diagnostic data on this page is compiled from publicly available repair resources and technical service bulletins. Always have a qualified mechanic confirm the diagnosis before authorizing repairs on your Ford Bronco Sport.
Common Causes on Ford Bronco Sport
- VCT solenoid stuck on 1.5L or 2.0L EcoBoost engine
- Timing chain stretch on 1.5L EcoBoost (known issue at 60-100K miles)
- Low oil pressure causing VCT system to operate out of range
- Camshaft position sensor electrical fault from connector corrosion
Symptoms
- Hard starting or extended cranking before engine fires
- Rough idle with noticeable engine vibration
- Rattling or chain-slap noise on cold startup
- Reduced engine power and sluggish acceleration
- Check engine light illuminated
- Intermittent stalling at idle
Notes for Ford Bronco Sport
Escape 1.5L EcoBoost timing chains tend to stretch earlier than larger engines; monitor closely.