P0016 Ford Maverick
Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A) · Powertrain Code · Critical · Repair: Moderate
What is P0016?
The crankshaft and camshaft position sensors on bank 1 are out of sync. Often caused by a stretched timing chain, jumped timing, or a failed VVT solenoid.
When the Ford Maverick triggers code P0016 (crankshaft position - camshaft position correlation (bank 1 sensor a)), it typically points to an issue in the powertrain system. This is a critical severity code, so address it promptly to avoid further damage or safety concerns. Below you'll find the most common causes, symptoms, and repair options specific to the Ford Maverick.
This repair is rated moderate, meaning some experience and specialty tools required.
Diagnostic data on this page is compiled from publicly available repair resources and technical service bulletins. Always have a qualified mechanic confirm the diagnosis before authorizing repairs on your Ford Maverick.
Common Causes on Ford Maverick
- VCT solenoid stuck on 2.0L EcoBoost engine
- Timing chain stretch from extended oil change intervals
- Low oil level causing VCT system operation outside normal range
- Camshaft position sensor electrical drift
Symptoms
- Hard starting or extended cranking before engine fires
- Rough idle with noticeable engine vibration
- Rattling or chain-slap noise on cold startup
- Reduced engine power and sluggish acceleration
- Check engine light illuminated
- Intermittent stalling at idle
Notes for Ford Maverick
Maverick 2.0L EcoBoost is sensitive to oil change intervals; follow Ford maintenance schedule strictly.