P0016 Ford Ranger
Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A) · Powertrain Code · Critical · Repair: Moderate
What is P0016?
The crankshaft and camshaft position sensors on bank 1 are out of sync. Often caused by a stretched timing chain, jumped timing, or a failed VVT solenoid.
When the Ford Ranger triggers code P0016 (crankshaft position - camshaft position correlation (bank 1 sensor a)), it typically points to an issue in the powertrain system. This is a critical severity code, so address it promptly to avoid further damage or safety concerns. Below you'll find the most common causes, symptoms, and repair options specific to the Ford Ranger.
This repair is rated moderate, meaning some experience and specialty tools required.
Diagnostic data on this page is compiled from publicly available repair resources and technical service bulletins. Always have a qualified mechanic confirm the diagnosis before authorizing repairs on your Ford Ranger.
Common Causes on Ford Ranger
- VCT solenoid failure on 2.3L EcoBoost engine
- Timing chain tensioner failure causing chain slack
- Low oil pressure from extended oil change intervals
- Camshaft position sensor giving intermittent incorrect signal
Symptoms
- Hard starting or extended cranking before engine fires
- Rough idle with noticeable engine vibration
- Rattling or chain-slap noise on cold startup
- Reduced engine power and sluggish acceleration
- Check engine light illuminated
- Intermittent stalling at idle
Notes for Ford Ranger
Ranger 2.3L EcoBoost shares the engine platform with Mustang; same diagnostic approach.