What causes P0016 on a Kia Telluride?

Common causes of P0016 on Kia Telluride: Timing chain stretch on 3.8L Lambda V6 engine; VVT oil control valve stuck from degraded oil on high-mileage engines; Camshaft position sensor failure from heat exposure; Low oil pressure from worn oil pump drive assembly.

P0016

P0016 Kia Telluride

Q: How much does it cost to fix P0016 on a Kia Telluride?

Fixes for P0016 on Kia Telluride include: Replace timing chain kit on both banks of the 3.8L V6, Replace VVT oil control valves on both banks and flush engine oil, Replace camshaft position sensor and verify signal quality, Check oil pressure with mechanical gauge; replace oil pump if low.

Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A) · Powertrain Code · Critical

What is P0016?

The crankshaft and camshaft position sensors on bank 1 are out of sync. Often caused by a stretched timing chain, jumped timing, or a failed VVT solenoid.

When the Kia Telluride triggers code P0016 (crankshaft position - camshaft position correlation (bank 1 sensor a)), it typically points to an issue in the powertrain system. This is a critical severity code, so address it promptly to avoid further damage or safety concerns. Below you'll find the most common causes, symptoms, and repair options specific to the Kia Telluride.

Diagnostic data on this page is compiled from publicly available repair resources and technical service bulletins. Always have a qualified mechanic confirm the diagnosis before authorizing repairs on your Kia Telluride.

Common Causes on Kia Telluride

Timing chain stretch on 3.8L Lambda V6 engine
VVT oil control valve stuck from degraded oil on high-mileage engines
Camshaft position sensor failure from heat exposure
Low oil pressure from worn oil pump drive assembly

Symptoms

Hard starting or extended cranking before engine fires
Rough idle with noticeable engine vibration
Rattling or chain-slap noise on cold startup
Reduced engine power and sluggish acceleration
Check engine light illuminated
Intermittent stalling at idle

Recommended Fixes

Replace timing chain kit on both banks of the 3.8L V6

Replace VVT oil control valves on both banks and flush engine oil

Replace camshaft position sensor and verify signal quality

Check oil pressure with mechanical gauge; replace oil pump if low

Notes for Kia Telluride

Palisade/Telluride 3.8L V6 timing chain jobs require significant labor; replace both banks together.

P0016 Kia Telluride

What is P0016?

Common Causes on Kia Telluride

Symptoms

Notes for Kia Telluride

Check Kia Telluride Specs