1995 Land Rover Discovery
Vehicle Specs & Maintenance Data
The 1995 Land Rover Discovery maintenance specs on this page cover the key fluids, torque values, and wear items you need for routine service. Use these numbers as a quick reference when performing oil changes, tire rotations, brake jobs, and other scheduled maintenance on your Land Rover Discovery.
For oil changes, the 1995 Land Rover Discovery takes 5W-30 Full Synthetic motor oil with a capacity of 7.5 quarts. Brake fluid type is DOT 4, the recommended coolant is OAT Coolant (Orange), and transmission fluid is ZF Lifeguard 8 (ATF). Always use the manufacturer-recommended fluids to maintain warranty coverage and engine longevity.
When mounting wheels on the Land Rover Discovery, torque the lug nuts to 90-95 ft-lbs using a calibrated torque wrench. Over- or under-torquing can lead to warped brake rotors or loose wheels. Re-torque after 50 to 100 miles on newly installed wheels.
There are 4 NHTSA safety recalls on file for the 1995 Land Rover Discovery. Check the Recalls tab below for full details.
Specifications on this page are compiled from multiple publicly available sources including manufacturer documentation, NHTSA data, and automotive databases. Always cross-reference with your owner's manual or official factory documentation before purchasing parts or performing any service.
The 1995 Land Rover Discovery uses 5W-30 Full Synthetic motor oil (7.5 qt capacity), requires lug nuts torqued to 90-95 ft-lbs, takes DOT 4 brake fluid.
Enter a diagnostic trouble code to see causes, symptoms, and fixes for the 1995 Land Rover Discovery.
No known problems reported for this vehicle yet.
4 NHTSA safety recalls for the 1995 Land Rover Discovery. Check your VIN at NHTSA.gov
POWER TRAIN:DRIVELINE:DRIVESHAFT
JAGUAR LAND ROVER NORTH AMERICA, INC. (LAND ROVER) IS RECALLING CERTAIN REAR DRIVESHAFT COUPLINGS, LAND ROVER BRANDED PART NUMBER TVF100010, MANUFACTURED FROM APRIL 2011 THROUGH NOVEMBER 2011, SOLD FOR USE AS SERVICE PARTS FOR CERTAIN MODEL YEAR 1995-1999 DISCOVERY, 1999-2004 DISCOVERY II, AND 1995 RANGE ROVER CLASSIC VEHICLES. SOME OF THE REAR DRIVESHAFT COUPLINGS MAY NOT HAVE BEEN MANUFACTURED TO THE REQUIRED ENGINEERING DESIGN SPECIFICATIONS AND MAY EXHIBIT THE ONSET OF JOINT SEPARATION, PRECLUDED BY DRIVE LINE VIBRATION.
IF THIS INCREASED VIBRATION WARNING SIGN IS IGNORED, CATASTROPHIC FAILURE OF THE DRIVE COUPLING CAN OCCUR. THE DRIVESHAFT MAY DETACH FROM THE VEHICLE WHILE IN MOTION RESULTING IN LOSS OF DRIVE AND LOSS OF TRANSMISSION PARK FUNCTIONALITY, INCREASING THE RISK OF A VEHICLE CRASH AND/OR INJURY.
LAND ROVER WILL NOTIFY OWNERS, AND DEALERS WILL REPLACE THE AFFECTED REAR DRIVESHAFT COUPLERS FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MAY 4, 2012. OWNERS MAY CONTACT JAGUAR LAND ROVER NORTH AMERICA AT 1-201-818-8500.
AIR BAGS:FRONTAL
VEHICLE DESCRIPTION: PASSENGER VEHICLES. AS A RESULT OF CHAFFING OF A CRUISE CONTROL WIRE, THE STEERING WHEEL ROTARY COUPLER CAN OVERHEAT AND INADVERTENTLY DEPLOY THE DRIVER'S AIR BAG.
DEPLOYMENT OF THE AIR BAG RESTRAINT SYSTEM WITHOUT WARNING CAN CAUSE A DRIVER TO LOSE VEHICLE CONTROL.
DEALERS WILL INSTALL A FUSIBLE LINK WHICH WILL PROTECT THE ROTARY COUPLER FROM OVERHEATING.
STRUCTURE:BODY:DOOR:HINGE AND ATTACHMENTS
THE RIGHT FRONT DOOR CAN FAIL TO LATCH FULLY WHEN CLOSING, CAUSING THE DOOR TO "BOUNCE" BACK OFF THE DOOR SEALS.
THIS CONDITION COULD CAUSE UNEXPECTED OPENING OF THE DOOR INCREASING THE RISK OF A VEHICLE ACCIDENT OR PERSONAL INJURY.
DEALERS WILL INSTALL CORRECTIVE HARDWARE ON THE RIGHT FRONT DOOR. DELAERS WILL ALSO CHECK THE DOOR LATCHES FOR THE OTHER DOORS AT THE SAME TIME.
POWER TRAIN:AXLE ASSEMBLY
AT PORT OF ENTRY, A QUALITY OVERCHECK OF THE DIFFERENTIAL PINION SHAFT TORQUE WAS PERFORMED. THIS CHECK REQUIRED THE REMOVAL OF THE DRIVESHAFTS. WHEN THE DRIVESHAFTS WERE REINSTALLED, THE WRONG SIZED NUTS WERE USED.
THE NUTS CAN LOOSEN, ULTIMATELY CAUSING THE DISCONNECTION OF ONE OR BOTH OF THE DRIVESHAFTS RESULTING IN LOSS OF CONTROL OF THE VEHICLE.
DEALERS WILL REPLACE THE HARDWARE ON THE INVOLVED VEHICLES WITH HARDWARE OF THE APPROPRIATE SPECIFICATIONS.