2000 Saab 9-5
Vehicle Specs & Maintenance Data
The 2000 Saab 9-5 maintenance specs on this page cover the key fluids, torque values, and wear items you need for routine service. Use these numbers as a quick reference when performing oil changes, tire rotations, brake jobs, and other scheduled maintenance on your Saab 9-5.
For oil changes, the 2000 Saab 9-5 takes 5W-30 Full Synthetic motor oil with a capacity of 4 quarts. Brake fluid type is DOT 4, the recommended coolant is Dex-Cool (OAT), and transmission fluid is Dexron VI. Always use the manufacturer-recommended fluids to maintain warranty coverage and engine longevity.
When mounting wheels on the Saab 9-5, torque the lug nuts to 80 ft-lbs using a calibrated torque wrench. Over- or under-torquing can lead to warped brake rotors or loose wheels. Re-torque after 50 to 100 miles on newly installed wheels.
There are 3 NHTSA safety recalls on file for the 2000 Saab 9-5. Check the Recalls tab below for full details.
Specifications on this page are compiled from multiple publicly available sources including manufacturer documentation, NHTSA data, and automotive databases. Always cross-reference with your owner's manual or official factory documentation before purchasing parts or performing any service.
The 2000 Saab 9-5 uses 5W-30 Full Synthetic motor oil (4 qt capacity), requires lug nuts torqued to 80 ft-lbs, takes DOT 4 brake fluid.
Enter a diagnostic trouble code to see causes, symptoms, and fixes for the 2000 Saab 9-5.
No known problems reported for this vehicle yet.
3 NHTSA safety recalls for the 2000 Saab 9-5. Check your VIN at NHTSA.gov
ELECTRICAL SYSTEM:IGNITION:MODULE
CERTAIN PASSENGER VEHICLES EQUIPPED WITH B205/B235 4-CYLINDER GASOLINE ENGINES AND B308 6-CYLINDER GASOLINE ENGINES MAY EXPERIENCE OVERHEATING AND BURNOUT OF THE ISOLATED GATED BIPOLAR TRANSISTOR (IGBT) WITHIN THE IGNITION DISCHARGE MODULE (IDM) DUE TO INCREASED SUSCEPTIBILITY TO ELECTRICAL LOADS.
OVERHEATING OF THE IGBT OCCURS MOST OFTEN AT ENGINE START-UP, BUT IT MAY ALSO OCCUR WHILE THE ENGINE IS RUNNING. ENGINE STALLING MAY OCCUR, WHICH COULD RESULT IN A CRASH.
DEALERS WILL INSPECT TO SEE WHAT VERSION IDM IS IN THE VEHICLE AND REPLACE THE IDM IF IT IS A VERSION BUILT PRIOR TO THE INTRODUCTION OF QP3. AN INTERIM LETTER WILL BE MAILED TO OWNERS IN OCTOBER 2005, INFORMING THEM OF THE CONDITION. PARTS ARE NOW AVAILABLE AND OWNERS WILL BE NOTIFIED TO BRING THEIR VEHICLES IN TO THE DEALERS TO HAVE THE IDM REPLACED BY LETTER DATED MARCH 13, 2006. OWNERS MAY CONTACT SAAB AT 1-800-955-9007.
WHEELS:HUB
ON CERTAIN PASSENGER VEHICLES, IF AN OWNER CHANGES THEIR WHEELS/TIRES BETWEEN SUMMER AND WINTER USING A STEEL WHEEL IN THE WINTER AND AN ALLOY WHEEL IN THE SUMMER, IT IS POSSIBLE FOR RUST AND CONTAMINATION TO BUILD UP ON THE WHEEL HUB DURING THE STEEL WHEEL USAGE. IF THIS OCCURS AND THE CONTAMINATION IS NOT REMOVED, IT IS POSSIBLE THAT AFTER THE TIRE CHANGE SERVICE, SOME OF THIS CONTAMINATION COULD FLAKE OR GRIND AWAY RESULTING IN REDUCED CLAMPING FORCE OF THE WHEEL TO THE HUB. OVER SEVERAL SEASONS, IT IS POSSIBLE THAT THIS REDUCED FORCE COULD RESULT IN FRACTURES DEVELOPING IN THE WHEEL BOLTS DUE TO WHEEL TO HUB MOVEMENT.
THESE FRACTURES WOULD RESULT IN WHEEL BOLT BREAKAGE, ALLOWING THE WHEEL TO DETACH FROM THE WHEEL HUB, INCREASING THE RISK OF A CRASH.
OWNERS WILL BE CONTACTED BY MAIL AND ASKED WHETHER THEY CHANGE BETWEEN STEEL AND ALLOY WHEELS. IF THEY DO ENGAGE IN THIS PRACTICE, THEY WILL BE INSTRUCTED TO BRING THEIR CARS TO AN AUTHORIZED DEALER. THE DEALER WILL REMOVE THE WHEELS, CLEAN ANY CONTAMINATION FROM THE WHEEL AND WHEEL HUB, AND REPLACE THE WHEELS USING NEW IMPROVED BOLTS WITH ATTACHED WASHERS. OWNER NOTIFICATION BEGAN MARCH 31, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT SAAB AT 1-800-955-9007.
AIR BAGS
VEHICLE DESCRIPTION: CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH REQUIREMENTS OF FMVSS NO. 208, "OCCUPANT CRASH PROTECTION." THE AIR BAG ALERT LABELS MAY NOT BE PERMANENTLY AFFIXED AS REQUIRED BY THIS STANDARD.
THESE VEHICLES DO NOT COMPLY WITH THE REQUIREMENTS.
DEALERS WILL CLEAN THE SUNVISOR SURFACE AND APPLY A NEW AIR BAG ALERT LABEL ON BOTH SUNVISORS. OWNER NOTIFICATION BEGAN JULY 30, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT SAAB AT 1-800-955-9007.