2017 Hyundai Azera
Vehicle Specs & Maintenance Data
The 2017 Hyundai Azera maintenance specs on this page cover the key fluids, torque values, and wear items you need for routine service. Use these numbers as a quick reference when performing oil changes, tire rotations, brake jobs, and other scheduled maintenance on your Hyundai Azera.
For oil changes, the 2017 Hyundai Azera takes 5W-20 Full Synthetic motor oil with a capacity of 5.8 quarts. Brake fluid type is DOT 3, the recommended coolant is Phosphate-based Green/Blue, and transmission fluid is SP-IV-M (ATF). Always use the manufacturer-recommended fluids to maintain warranty coverage and engine longevity.
When mounting wheels on the Hyundai Azera, torque the lug nuts to 80 ft-lbs using a calibrated torque wrench. Over- or under-torquing can lead to warped brake rotors or loose wheels. Re-torque after 50 to 100 miles on newly installed wheels.
Owners of the 2017 Hyundai Azera have reported 5 common issues including "Engine Knock Sensor Failure", "Automatic Transmission Harsh Shifting and Hesitation" and "Electrical System and Battery Drain Issues". Scroll down to the Diagnostics tab for detailed descriptions, solutions, and estimated repair costs.
Specifications on this page are compiled from multiple publicly available sources including manufacturer documentation, NHTSA data, and automotive databases. Always cross-reference with your owner's manual or official factory documentation before purchasing parts or performing any service.
The 2017 Hyundai Azera uses 5W-20 Full Synthetic motor oil (5.8 qt capacity), requires lug nuts torqued to 80 ft-lbs, takes DOT 3 brake fluid.
Manufacturer-recommended maintenance schedule for the 2017 Hyundai Azera. Always verify intervals against your owner's manual.
Enter a diagnostic trouble code to see causes, symptoms, and fixes for the 2017 Hyundai Azera.
Common problems reported by 2017 Hyundai Azera owners, with recommended fixes and estimated repair costs.
Engine Knock Sensor Failure
The 2012 Azera's 3.3L Lambda II V6 engine is prone to knock sensor failure, triggering a check engine light and causing the ECU to retard ignition timing as a protective measure. This results in reduced power, decreased fuel economy, and a noticeable hesitation during acceleration. The issue is widespread on 2012-2014 Azera models.
Replace the faulty knock sensor(s) — the 3.3L V6 has two knock sensors located beneath the intake manifold. Clearing the codes after replacement allows the ECU to resume normal timing. Have the dealer verify no actual engine knock exists before attributing symptoms solely to the sensor.
Est. Cost: $250 - $600 for knock sensor replacement (labor-intensive due to intake manifold removal)Automatic Transmission Harsh Shifting and Hesitation
The 6-speed automatic transmission in the 2012 Azera can develop harsh shifting, delayed engagement from a stop, and hunting between gears during light throttle driving. Some owners report a pronounced clunk when shifting from Park to Drive or Reverse, and the transmission may hesitate for several seconds before engaging.
Have the dealer perform a TCU software update, as Hyundai released updated shift logic calibrations. If shifting issues persist, a transmission fluid flush with Hyundai SP-IV fluid may improve shift quality. In severe cases, the valve body or solenoid pack may need replacement.
Est. Cost: $0 under warranty for software update; $200 - $400 for fluid flush; $800 - $1,800 for valve bodyElectrical System and Battery Drain Issues
The 2012 Azera suffers from parasitic battery drain issues that can leave the vehicle dead after sitting overnight. Common culprits include the trunk latch switch, infotainment system failing to enter sleep mode, and the Bluetooth module drawing excessive current when the vehicle is off.
Have the dealer perform a parasitic draw test to identify the offending circuit. Common fixes include replacing the trunk latch switch assembly, updating the infotainment system software, and replacing the Bluetooth module. Ensure all interior lights fully extinguish after door closure.
Est. Cost: $100 - $300 for diagnosis; $150 - $500 for component replacementAir Conditioning Compressor Failure
The A/C compressor in the 2012 Azera is prone to premature failure, often accompanied by a seized clutch bearing that produces a loud grinding noise when the A/C is engaged. When the compressor fails, metallic debris contaminates the entire A/C system, requiring extensive repair.
Replace the A/C compressor, receiver/dryer, and expansion valve. Flush the condenser and evaporator to remove metallic debris from the failed compressor. If debris is extensive, the condenser may also need replacement. Use only PAG 46 oil specified for the system.
Est. Cost: $800 - $1,600 for compressor and system servicePanoramic Sunroof Rattle and Wind Noise
The panoramic sunroof on the 2012 Azera develops rattles and wind noise over time due to worn weatherstripping seals and loose track guides. The glass panel may also vibrate at highway speeds, creating an annoying buzzing sound that reverberates through the cabin.
Have the dealer inspect and replace the sunroof weatherstripping seals. Lubricate the sunroof track rails with silicone spray. Tighten or replace the sunroof track guides if loose. In some cases, the glass panel alignment may need adjustment to eliminate wind noise.
Est. Cost: $200 - $600 for seal and track service; $400 - $1,000 for panel realignment