1995 Chevrolet Tahoe
Vehicle Specs & Maintenance Data
The 1995 Chevrolet Tahoe maintenance specs on this page cover the key fluids, torque values, and wear items you need for routine service. Use these numbers as a quick reference when performing oil changes, tire rotations, brake jobs, and other scheduled maintenance on your Chevrolet Tahoe.
For oil changes, the 1995 Chevrolet Tahoe takes 5W-30 motor oil with a capacity of 5 quarts. Brake fluid type is DOT 3, the recommended coolant is Dex-Cool (OAT), and transmission fluid is Dexron VI. Always use the manufacturer-recommended fluids to maintain warranty coverage and engine longevity.
When mounting wheels on the Chevrolet Tahoe, torque the lug nuts to 120 ft-lbs using a calibrated torque wrench. Over- or under-torquing can lead to warped brake rotors or loose wheels. Re-torque after 50 to 100 miles on newly installed wheels.
There are 8 NHTSA safety recalls on file for the 1995 Chevrolet Tahoe. Check the Recalls tab below for full details.
Specifications on this page are compiled from multiple publicly available sources including manufacturer documentation, NHTSA data, and automotive databases. Always cross-reference with your owner's manual or official factory documentation before purchasing parts or performing any service.
The 1995 Chevrolet Tahoe uses 5W-30 motor oil (5 qt capacity), requires lug nuts torqued to 120 ft-lbs, takes DOT 3 brake fluid.
Enter a diagnostic trouble code to see causes, symptoms, and fixes for the 1995 Chevrolet Tahoe.
No known problems reported for this vehicle yet.
8 NHTSA safety recalls for the 1995 Chevrolet Tahoe. Check your VIN at NHTSA.gov
EQUIPMENT
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.
THIS CONDITION MAY CAUSE INADEQUATE SEALING AND LOSS OF ENGINE OIL, POSSIBLY RESULTING IN A FIRE.
HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.
FUEL SYSTEM, GASOLINE
CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.
THIS CONDITION MAY CAUSE AN INADEQUATE SEAL AT THE CONNECTION, POTENTIALLY LEADING TO A FUEL LEAK. IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.
HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).
VISIBILITY:WINDSHIELD WIPER/WASHER
ON CERTAIN MINIVANS, PICKUP TRUCKS, AND SPORT UTILITY VEHICLES WITH CERTAIN MODEL-ENGINE COMBINATIONS, THE WINDSHIELD WIPER MOTOR MAY FAIL DUE TO CRACKED SOLDER JOINTS ON THE CONTROLLER CIRCUIT BOARD. THE WINDSHIELD WIPERS COULD WORK INTERMITTENTLY OR NOT AT ALL.
IF THIS WERE TO OCCUR DURING BAD WEATHER, DRIVER VISIBILITY WOULD BE REDUCED, WHICH COULD RESULT IN A CRASH.
DEALERS WILL REPLACE THE WIPER MOTOR CIRCUIT BOARD AND COVER. OWNER NOTIFICATION BEGAN ON JUNE 19, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CHEVROLET AT 1-800-222-1020, GMC AT 1-800-462-8782, OR OLDSMOBILE AT 1-800-442-6537.
VISIBILITY:WINDSHIELD WIPER/WASHER
VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND SPORT UTILITY VEHICLES, 2 AND 4-WHEEL DRIVE. SOLDER JOINTS NEAR THE WIRING HARNESS CONNECTOR CAN CRACK CAUSING THE WINDSHIELD WIPERS TO WORK INTERMITTENTLY.
THIS CONDITION CAN RESULT IN INOPERATIVE WIPERS, REDUCING A DRIVER'S VISIBILITY, AND INCREASING THE RISK OF A VEHICLE CRASH.
DEALERS WILL REPLACE THE WIPER MOTOR CIRCUIT BOARD AND COVER.
VEHICLE SPEED CONTROL
THESE VEHICLES WERE ASSEMBLED WITH THE THROTTLE CABLE CONTACTING THE DASH MAT WHICH COULD BIND THE THROTTLE. THIS DOES NOT MEET WITH THE MAXIMUM RETURN TIMES REQUIRED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, "ACCELERATOR CONTROL SYSTEMS."
CONSEQUENCE OF NON-COMPLIANCE: THE ENGINE SPEED MAY NOT RETURN TO IDLE INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.
DEALERS WILL INSPECT FOR ADEQUATE THROTTLE CABLE TO DASH MAT CLEARANCE, AND IF THERE IS INSUFFICIENT CLEARANCE, CUT OUT A PORTION OF THE DASH MAT TO PROVIDE PROPER CLEARANCE.
POWER TRAIN:AUTOMATIC TRANSMISSION
THE TRANSMISSION SHIFT-CABLE LOCK CLIP CAN BACK OUT OF ITS INSTALLED POSITION RESULTING IN A LOSS OF CABLE ADJUSTMENT. WHEN THE SHIFT LEVER IS PLACED IN THE "PARK" POSITION, THE "PARK" INDICATOR LIGHT MAY NOT ILLUMINATE.
THE VEHICLE CAN MOVE UNINTENTIONALLY IF THE DRIVER DOES NOT NOTICE THAT THE INDICATOR LIGHT IS NOT ON AND DOES NOT APPLY THE PARKING BRAKE.
DEALERS WILL ADJUST THE SHIFT CABLE AND INSTALL A LOCK CLIP.
AIR BAGS
THE VEHICLES HAVE BOTH THE SUPPLEMENTAL INFLATABLE RESTRAINT (SIR) LABEL AND AN ENGINE START LABEL INSTALLED ON THE SAME SIDE OF THE SUN VISOR. THIS DOES NOT COMPLY WITH FMVSS NO.208, "OCCUPANT CRASH PROTECTION."
CONSEQUENCE OF NON-COMPLIANCE: OPERATORS COULD FAIL TO NOTICE AND HEED THE WARNING LABEL.
THE ENGINE START LABEL WILL BE REMOVED FROM THE STOWED SIDE OF THE SUN VISOR AND A NEW ENGINE START LABEL WILL BE INSTALLED ON THE HEADLINER IN THE SUN VISOR DEPRESSION. OWNERS WILL RECEIVE THE NEW LABEL AND CAN INSTALL THE LABEL THEMSELVES OR HAVE A DEALER INSTALL IT.
SEAT BELTS:REAR/OTHER
VEHICLES FAIL TO CONFORM TO FMVSS NO. 210, "SEAT BELT ANCHORAGES." THE CENTER REAR SEAT LAP BELT WAS IMPROPERLY ROUTED.
CONSEQUENCE OF NON-COMPLIANCE: THE OCCUPANT OF THIS SEAT WILL NOT BE PROPERLY RESTRAINED IN THE EVENT OF A VEHICLE CRASH.
INSTRUCTIONS FOR REROUTING THE CENTER REAR SEAT LAP BELT WILL BE SENT TO THE VEHICLE OWNERS. IF THE OWNER PREFERS, THEY CAN TAKE THEIR VEHICLE TO THEIR DEALER AND HAVE IT REROUTED FREE OF CHARGE BY THE DEALER.