2002 Dodge Durango
Vehicle Specs & Maintenance Data
The 2002 Dodge Durango maintenance specs on this page cover the key fluids, torque values, and wear items you need for routine service. Use these numbers as a quick reference when performing oil changes, tire rotations, brake jobs, and other scheduled maintenance on your Dodge Durango.
For oil changes, the 2002 Dodge Durango takes 5W-30 motor oil with a capacity of 5 quarts. Brake fluid type is DOT 3, the recommended coolant is Mopar OAT (Purple/Violet), and transmission fluid is ATF+4. Always use the manufacturer-recommended fluids to maintain warranty coverage and engine longevity.
When mounting wheels on the Dodge Durango, torque the lug nuts to 85-115 ft-lbs using a calibrated torque wrench. Over- or under-torquing can lead to warped brake rotors or loose wheels. Re-torque after 50 to 100 miles on newly installed wheels.
There are 6 NHTSA safety recalls on file for the 2002 Dodge Durango. Check the Recalls tab below for full details.
Specifications on this page are compiled from multiple publicly available sources including manufacturer documentation, NHTSA data, and automotive databases. Always cross-reference with your owner's manual or official factory documentation before purchasing parts or performing any service.
The 2002 Dodge Durango uses 5W-30 motor oil (5 qt capacity), requires lug nuts torqued to 85-115 ft-lbs, takes DOT 3 brake fluid.
Enter a diagnostic trouble code to see causes, symptoms, and fixes for the 2002 Dodge Durango.
No known problems reported for this vehicle yet.
6 NHTSA safety recalls for the 2002 Dodge Durango. Check your VIN at NHTSA.gov
SUSPENSION:FRONT:HUB
SKF IS RECALLING 2,805 HUB UNITS, PART NO. BR930361, SOLD AS A SERVICE PART FOR 1997-2004 DODGE DAKOTA VEHICLES AND 1999-2003 DODGE DURANGO VEHICLES EQUIPPED WITH 2-WHEEL DRIVE & REAR AXLE ABS. DUE TO A SPECIFICATION ERROR, THE ROTOR PILOT FOR THE HUB UNIT MAY BE TOO LONG. THIS RESULTS IN THE WHEEL TO NOT BE SEATED FULLY AGAINST THE HUB FLANGE FACE DURING MOUNTING.
IMPROPER SEATING OF THE WHEEL CAN RESULT IN EXCESSIVE VIBRATION, BRAKE ROTOR NOISE, DIFFICULTY REMOVING THE WHEEL AFTER INSTALLATION AND OPERATION OF THE VEHICLE, AND POSSIBLY WHEEL-END SEPARATION DURING VEHICLE OPERATION. SHOULD WHEEL-END SEPARATION OCCUR, THE DRIVER COULD LOOSE CONTROL OF THE VEHICLE, POSSIBLY RESULTING IN A CRASH.
SKF WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE HUB UNITS FREE OF CHARGE. THE RECALL BEGAN ON NOVEMBER 5, 2008. OWNERS MAY CONTACT SKF VSM NORTH AMERICA CUSTOMER SERVICE AT 1-800-644-8999.
POWER TRAIN:AUTOMATIC TRANSMISSION:LEVER AND LINKAGE:COLUMN SHIFT
ON CERTAIN VAN AND PICKUP TRUCKS EQUIPPED WITH AUTOMATIC TRANSMISSIONS, THE IGNITION/PARK SHIFT INTERLOCK SYSTEM MAY BECOME INOPERATIVE. THIS CAN ALLOW THE SHIFTER TO BE MOVED OUT OF THE "PARK" POSITION WITH THE IGNITION KEY REMOVED (OR IN THE "LOCK" POSITION). THIS CAN ALSO ALLOW THE IGNITION KEY TO BE REMOVED WHEN THE SHIFTER HAS NOT BEEN PLACED IN THE "PARK" POSITION.
EITHER OF THESE CONDITIONS COULD ALLOW THE VEHICLE TO ROLL AWAY CAUSING A CRASH WITHOUT WARNING.
DEALERS WILL REPLACE THE GEARSHIFT BLOCKER AND BRACKET ASSEMBLY FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN DURING JANUARY 2008. OWNERS MAY CONTACT CHRYSLER AT 1-800-853-1403.
ELECTRICAL SYSTEM
ON CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH FRONT BENCH SEATS ONLY, IF FLUID IS SPILLED FROM THE FLOOR MOUNTED CUP HOLDER, AN UNUSED CONSOLE POWER OUTLET CONNECTOR LOCATED UNDER THE SEAT MAY BECOME CONTAMINATED.
THIS MAY ALLOW DEVELOPMENT OF A HIGH RESISTIVE SHORT CIRCUIT IN THE CONNECTOR, WHICH COULD EVENTUALLY LEAD TO A FIRE.
DEALERS WILL INSPECT THE CONSOLE WIRING CONNECTOR FOR CORROSION, CLEAN AS REQUIRED, AND INSTALL A CAP TO PREVENT ADDITIONAL FLUID FROM CONTAMINATING THE CONNECTOR FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 30, 2006. OWNERS MAY CONTACT DAIMLER CHRYSLER AT 1-800-853-1403.
ENGINE AND ENGINE COOLING
CERTAIN REPLACEMENT K&N FUEL PERFORMANCE KITS, P/NOS. 57-1509, 57-1511, 57-1511-1, 57-1517, 57-1517-1, 57-1527, AND 57-1530. ALSO, A SMALL PERCENTAGE OF THESE KITS WERE SOLD UNDER THE MOPAR PERFORMANCE PARTS BRAND NAME (P/NOS. P5007069 AND P5007070). ALL KITS WERE MANUFACTURED FROM APRIL 20, 1999, THROUGH SEPTEMBER 23, 2004. THESE ASSEMBLIES WERE MANUFACTURED AS REPLACEMENT EQUIPMENT FOR CERTAIN DODGE PICKUP TRUCKS AND SUVS. A SMALL PIECE OF MATERIAL FROM THE TUBE WALL COULD BE SUCKED INTO THE ENGINE THROTTLE BODY, WHICH COULD CAUSE THE THROTTLE TO BECOME JAMMED IN THE OPEN POSITION.
A JAMMED OPEN THROTTLE COULD CAUSE UNINTENDED ACCELERATION OF THE VEHICLE, POSSIBLY RESULTING IN A CRASH OR INCREASED STOPING DISTANCES WHEN BRAKING.
K&N WILL PROVIDE OWNERS WITH A FREE REPAIR KIT ALONG WITH REPAIR INSTRUCTIONS. THE RECALL BEGAN ON APRIL 20, 2006.
SUSPENSION:FRONT:CONTROL ARM:UPPER BALL JOINT
ON CERTAIN SPORT UTILITY VEHICLES AND PICKUP TRUCKS EQUIPPED WITH FOUR-WHEEL DRIVE (4X4), IF MOISTURE LEAKS INTO THE FRONT SUSPENSION UPPER BALL JOINT, EVACUATION OF THE LUBRICANT AND CORROSION OF THE JOINT MAY CAUSE THE JOINT TO WEAR OVER AN EXTENDED PERIOD OF TIME. THIS COULD CAUSE A CLUNKING NOISE IN THE FRONT SUSPENSION, WHICH MAY NOT ALWAYS BE HEARD BY THE VEHICLE OCCUPANTS.
EXCESSIVE WEAR IN THE UPPER BALL JOINT MAY ALLOW IT TO SEPARATE, WHICH COULD RESULT IN LOSS OF CONTROL OF THE VEHICLE.
DEALERS WILL REPLACE THE FRONT SUSPENSION UPPER BALL JOINTS. THIS SAFETY IMPROVEMENT CAMPAIGN BEGAN ON DECEMBER 21, 2004. OWNERS CAN CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
VISIBILITY:WINDSHIELD WIPER/WASHER
ON CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES, THE WINDSHIELD WIPER MODULE MOTOR MAY BE SUSCEPTIBLE TO WATER INTRUSION THAT COULD CAUSE INTERNAL CORROSION AND RESULT IN PARTIAL OR COMPLETE LOSS OF FRONT WINDSHIELD WIPING CAPABILITY.
DRIVER VISIBILITY COULD BE REDUCED, WHICH COULD RESULT IN A CRASH.
DEALERS WILL REPLACE THE FRONT WINDSHIELD WIPER MODULE. OWNER NOTIFICATION BEGAN ON JULY 12, 2004. OWNERS SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.