2002 Saab 9-5
Vehicle Specs & Maintenance Data
The 2002 Saab 9-5 maintenance specs on this page cover the key fluids, torque values, and wear items you need for routine service. Use these numbers as a quick reference when performing oil changes, tire rotations, brake jobs, and other scheduled maintenance on your Saab 9-5.
For oil changes, the 2002 Saab 9-5 takes 5W-30 Full Synthetic motor oil with a capacity of 5.5 quarts. Brake fluid type is DOT 4, the recommended coolant is Dex-Cool (OAT), and transmission fluid is Dexron VI. Always use the manufacturer-recommended fluids to maintain warranty coverage and engine longevity.
When mounting wheels on the Saab 9-5, torque the lug nuts to 80 ft-lbs using a calibrated torque wrench. Over- or under-torquing can lead to warped brake rotors or loose wheels. Re-torque after 50 to 100 miles on newly installed wheels.
There are 6 NHTSA safety recalls on file for the 2002 Saab 9-5. Check the Recalls tab below for full details.
Specifications on this page are compiled from multiple publicly available sources including manufacturer documentation, NHTSA data, and automotive databases. Always cross-reference with your owner's manual or official factory documentation before purchasing parts or performing any service.
The 2002 Saab 9-5 uses 5W-30 Full Synthetic motor oil (5.5 qt capacity), requires lug nuts torqued to 80 ft-lbs, takes DOT 4 brake fluid.
Enter a diagnostic trouble code to see causes, symptoms, and fixes for the 2002 Saab 9-5.
No known problems reported for this vehicle yet.
6 NHTSA safety recalls for the 2002 Saab 9-5. Check your VIN at NHTSA.gov
SEATS:FRONT ASSEMBLY:HEAD RESTRAINT
SAAB IS RECALLING 57,389 MY 2002-2008 9-5 SERIES VEHICLES FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACT." DURING COMPLIANCE TESTING, ONE OF THE UPPER INTERIOR OCCUPANT PROTECTION TEST POINTS EXCEEDED THE STANDARD'S REQUIREMENTS.
IN THE EVENT OF A VEHICLE CRASH, PERSONAL INJURY TO OCCUPANTS MAY OCCUR.
DEALERS WILL INSTALL A-PILLAR TRIM WITH IMPROVED ENERGY-ABSORBING CAPABILITY FREE OF CHARGE. THE RECALL BEGAN ON NOVEMBER 25, 2008. OWNERS MAY CONTACT SAAB AT 1-800-955-9007.
FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS
ON CERTAIN PASSENGER VEHICLES, THE FUEL PUMP RETAINING TABS HOLDING THE FUEL LINES WERE DAMAGED DURING PRODUCTION.
OVER TIME, THIS COULD CAUSE THE FUEL LINES TO LOOSEN FROM THE PUMP RESULTING IN FUEL LEAKAGE. IF AN IGNITION SOURCE WERE PRESENT, THE FUEL MAY IGNITE RESULTING IN A VEHICLE FIRE.
DEALERS WILL DEVELOP A SECURING BRACKET THAT WILL SECURE THE FUEL LINES TO THE FUEL PUMP EVEN IF THE PLASTIC RETAINING TABS SHOULD BREAK. THE RECALL BEGAN ON JUNE 13, 2007. THIS IS AN EXPANSION OF PREVIOUS RECALL CAMPAIGNS - SEE 04V557 AND 06V126. OWNERS MAY CONTACT SAAB AT 1-800-955-9007.
ELECTRICAL SYSTEM:IGNITION:MODULE
CERTAIN PASSENGER VEHICLES EQUIPPED WITH B308 6-CYLINDER GASOLINE ENGINES MAY EXPERIENCE OVERHEATING AND BURNOUT OF THE ISOLATED GATED BIPOLAR TRANSISTOR (IGBT) WITHIN THE IGNITION DISCHARGE MODULE (IDM) DUE TO INCREASED SUSCEPTIBILITY TO ELECTRICAL LOADS.
OVERHEATING OF THE IGBT OCCURS MOST OFTEN AT ENGINE START-UP, BUT IT MAY ALSO OCCUR WHILE THE ENGINE IS RUNNING. ENGINE STALLING MAY OCCUR, WHICH COULD RESULT IN A CRASH.
DEALERS WILL INSPECT TO SEE WHAT VERSION IDM IS IN THE VEHICLE AND REPLACE THE IDM IF IT IS A VERSION BUILT PRIOR TO JANUARY 2003. THE RECALL IS EXPECTED TO BEGIN DURING DECEMBER 2005. OWNERS MAY CONTACT SAAB AT 1-800-955-9007. NOTE: THIS RECALL IS AN EXPANSION OF A PREVIOUS CAMPAIGN (PLEASE SEE 05V399).
ELECTRICAL SYSTEM:IGNITION:MODULE
CERTAIN PASSENGER VEHICLES EQUIPPED WITH B205/B235 4-CYLINDER GASOLINE ENGINES AND B308 6-CYLINDER GASOLINE ENGINES MAY EXPERIENCE OVERHEATING AND BURNOUT OF THE ISOLATED GATED BIPOLAR TRANSISTOR (IGBT) WITHIN THE IGNITION DISCHARGE MODULE (IDM) DUE TO INCREASED SUSCEPTIBILITY TO ELECTRICAL LOADS.
OVERHEATING OF THE IGBT OCCURS MOST OFTEN AT ENGINE START-UP, BUT IT MAY ALSO OCCUR WHILE THE ENGINE IS RUNNING. ENGINE STALLING MAY OCCUR, WHICH COULD RESULT IN A CRASH.
DEALERS WILL INSPECT TO SEE WHAT VERSION IDM IS IN THE VEHICLE AND REPLACE THE IDM IF IT IS A VERSION BUILT PRIOR TO THE INTRODUCTION OF QP3. AN INTERIM LETTER WILL BE MAILED TO OWNERS IN OCTOBER 2005, INFORMING THEM OF THE CONDITION. PARTS ARE NOW AVAILABLE AND OWNERS WILL BE NOTIFIED TO BRING THEIR VEHICLES IN TO THE DEALERS TO HAVE THE IDM REPLACED BY LETTER DATED MARCH 13, 2006. OWNERS MAY CONTACT SAAB AT 1-800-955-9007.
WHEELS:HUB
ON CERTAIN PASSENGER VEHICLES, IF AN OWNER CHANGES THEIR WHEELS/TIRES BETWEEN SUMMER AND WINTER USING A STEEL WHEEL IN THE WINTER AND AN ALLOY WHEEL IN THE SUMMER, IT IS POSSIBLE FOR RUST AND CONTAMINATION TO BUILD UP ON THE WHEEL HUB DURING THE STEEL WHEEL USAGE. IF THIS OCCURS AND THE CONTAMINATION IS NOT REMOVED, IT IS POSSIBLE THAT AFTER THE TIRE CHANGE SERVICE, SOME OF THIS CONTAMINATION COULD FLAKE OR GRIND AWAY RESULTING IN REDUCED CLAMPING FORCE OF THE WHEEL TO THE HUB. OVER SEVERAL SEASONS, IT IS POSSIBLE THAT THIS REDUCED FORCE COULD RESULT IN FRACTURES DEVELOPING IN THE WHEEL BOLTS DUE TO WHEEL TO HUB MOVEMENT.
THESE FRACTURES WOULD RESULT IN WHEEL BOLT BREAKAGE, ALLOWING THE WHEEL TO DETACH FROM THE WHEEL HUB, INCREASING THE RISK OF A CRASH.
OWNERS WILL BE CONTACTED BY MAIL AND ASKED WHETHER THEY CHANGE BETWEEN STEEL AND ALLOY WHEELS. IF THEY DO ENGAGE IN THIS PRACTICE, THEY WILL BE INSTRUCTED TO BRING THEIR CARS TO AN AUTHORIZED DEALER. THE DEALER WILL REMOVE THE WHEELS, CLEAN ANY CONTAMINATION FROM THE WHEEL AND WHEEL HUB, AND REPLACE THE WHEELS USING NEW IMPROVED BOLTS WITH ATTACHED WASHERS. OWNER NOTIFICATION BEGAN MARCH 31, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT SAAB AT 1-800-955-9007.
STEERING:LINKAGES:KNUCKLE:SPINDLE:ARM
THE STEERING KNUCKLE CASTINGS ON CERTAIN PASSENGER VEHICLES MAY HAVE BEEN CONTAMINATED DURING THE CASTING PROCESS.
THESE KNUCKLES CAN BREAK, RESULTING IN POSSIBLE LOSS OF STEERING CONTROL.
DEALERS WILL INSPECT THE STEERING KNUCKLE FOR THE CASTING NUMBER. IF THE KNUCKLE WAS IN THE DEFECTIVE BATCH, THE STEERING KNUCKLE WILL BE REPLACED. OWNER NOTIFICATION IS EXPECTED TO BEGIN DURING JANUARY 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT SAAB AT 1-800-955-9007.