2005 Ford Focus
Vehicle Specs & Maintenance Data
The 2005 Ford Focus maintenance specs on this page cover the key fluids, torque values, and wear items you need for routine service. Use these numbers as a quick reference when performing oil changes, tire rotations, brake jobs, and other scheduled maintenance on your Ford Focus.
For oil changes, the 2005 Ford Focus takes 5W-30 Full Synthetic motor oil with a capacity of 5.7 quarts. Brake fluid type is DOT 3, the recommended coolant is Motorcraft Gold (OAT), and transmission fluid is Mercon LV. Always use the manufacturer-recommended fluids to maintain warranty coverage and engine longevity.
When mounting wheels on the Ford Focus, torque the lug nuts to 94 ft-lbs using a calibrated torque wrench. Over- or under-torquing can lead to warped brake rotors or loose wheels. Re-torque after 50 to 100 miles on newly installed wheels.
There are 5 NHTSA safety recalls on file for the 2005 Ford Focus. Check the Recalls tab below for full details.
Specifications on this page are compiled from multiple publicly available sources including manufacturer documentation, NHTSA data, and automotive databases. Always cross-reference with your owner's manual or official factory documentation before purchasing parts or performing any service.
The 2005 Ford Focus uses 5W-30 Full Synthetic motor oil (5.7 qt capacity), requires lug nuts torqued to 94 ft-lbs, takes DOT 3 brake fluid.
Enter a diagnostic trouble code to see causes, symptoms, and fixes for the 2005 Ford Focus.
No known problems reported for this vehicle yet.
5 NHTSA safety recalls for the 2005 Ford Focus. Check your VIN at NHTSA.gov
EQUIPMENT
RIDE CONTROL, LLC (RIDE CONTROL) IS RECALLING CERTAIN READYMOUNT ASSEMBLIES, P/N 746641MT AND 746646MT, WITH CORRESPONDING AFTERMARKET CUSTOMER PART NUMBERS: GABRIEL G56944 AND GABRIEL G56945, AND PRIVATELY BRANDED PARTSMASTER WITH PART NUMBERS G68944 AND G68945. THE READYMOUNT ASSEMBLIES WERE SOLD AS AFTERMARKET SERVICE EQUIPMENT FOR USE ON CERTAIN 2000 THROUGH 2005 FORD FOCUS VEHICLES. THESE ASSEMBLIES WERE ASSEMBLED WITH A NUT WITHOUT THE NECESSARY WASHER. THE ABSENCE OF THE WASHER CAN ALLOW THE READYMOUNT ASSEMBLY TO PULL APART THE TOP MOUNT.
IF THE ASSEMBLY SEPARATES DURING INSTALLATION, IT COULD RESULT IN INJURY TO THE INSTALLER. IF THE ASSEMBLY SEPARATES WHILE THE VEHICLE IS IN MOTION, IT COULD RESULT IN SECONDARY DAMAGE TO THE VEHICLE AND POSSIBLY RESULT IN A VEHICLE CRASH.
RIDE CONTROL WILL NOTIFY OWNERS AND WILL SET UP PROCEDURES TO INSPECT, REPAIR, AND/OR REPLACE THE AFFECTED PARTS WITHOUT CHARGE TO THE OWNER. THE SAFETY RECALL BEGAN ON MARCH 30, 2012. OWNERS MAY CONTACT RIDE CONTROL AT 1-800-999-3903.
EXTERIOR LIGHTING:HEADLIGHTS
K2 MOTOR IS RECALLING 1,921 AFTERMARKET HEADLAMPS OF VARIOUS MODELS SOLD FOR USE ON THE ABOVE LISTED VEHICLES. THESE HEADLAMPS ARE MISSING THE AMBER SIDE REFLEX REFLECTOR WHICH FAILS TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."
WITHOUT THE AMBER SIDE REFLEX REFLECTORS, THE LIGHTING VISIBILITY MAY BE AFFECTED, POSSIBLY RESULTING IN A VEHICLE CRASH.
K2 MOTOR WILL NOTIFY OWNERS AND OFFER A FULL REFUND. THE RECALL BEGAN ON DECEMEBER 17, 2008. OWNERS MAY CONTACT K2 MOTOR AT 1-909-839-2992.
FUEL SYSTEM, GASOLINE
CERTAIN AFTERMARKET FUEL FILTERS SOLD UNDER THE PUROLATOR BRAND NAME, P/N F65277, SHIPPED FROM JANUARY 16 THROUGH JUNE 2, 2006, FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. DUE TO INCORRECT DESIGN, THE QUICK CONNECTORS MAY NOT FULLY SEAT WITH THE TUBE INTERFACE, EVEN THOUGH THE PERSON MAKING THE CONNECTION MAY BELIEVE THAT THE QUICK CONNECTOR IS FULLY ATTACHED.
FAILURE OF THIS CONNECTION COULD LEAD TO FUEL SPILLAGE AND, IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.
UFI WILL NOTIFY OWNERS AND REPLACE THE FILTERS FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 4, 2006. OWNERS MAY CONTACT UFI FILTERS USA AT 800-230-5876.
EXTERIOR LIGHTING
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
WITHOUT THE AMBER REFLECTORS, THE VEHICLE WILL BE POORLY ILLUMINATED, POSSIBLY RESULTING IN A VEHICLE CRASH WITHOUT WARNING.
PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.
LATCHES/LOCKS/LINKAGES:DOORS:LATCH
CERTAIN PASSENGER VEHICLES WITH FOUR OR FIVE DOORS AND ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WEST VIRGINIA, WISCONSIN, AND THE DISTRICT OF COLUMBIA, A BUILD-UP OF CORROSION AT THE PAWL PIVOT AREA OF THE REAR DOOR LATCH CAN CAUSE A BINDING CONDITION OF THE PAWL THAT MAY AFFECT PROPER ENGAGEMENT OF THE PAWL INTO THE CATCH. THE OCCUPANT MAY EXPERIENCE DIFFICULTY OPENING OR CLOSING A REAR DOOR, AND EVENTUALLY THE REAR DOOR MAY NOT LATCH PROPERLY.
IF NOT LATCHED PROPERLY, THE DOOR MAY OPEN WHILE THE VEHICLE IS IN MOTION. IF AN OCCUPANT FELL OUT OF THE VEHICLE, PERSONAL INJURIES COULD OCCUR.
DEALERS WILL HAVE A LOWER ROCKER SEAL ADDED TO THE DOOR AND HAVE THE REAR DOOR LATCHES EVALUATED FREE OF CHARGE. A LATCH THAT PASSES THE EVALUATION WILL BE LUBRICATED TO PREVENT FUTURE CORROSION. A LATCH THAT DOES NOT PASS THE EVALUATION WILL BE REPLACED. IN ADDITION, A STICKER WILL BE AFFIXED TO THE REAR DOORS ADVISING THE OWNERS TO USE THE RECOMMENDED LUBRICANT. THE RECALL BEGAN ON MARCH 9, 2005. OWNERS MAY CONTACT FORD AT 1-800-392-3673.