2006 Dodge Magnum

The 2007 Magnum's TIPM is prone to relay and circuit board failures that cause a wide range of electrical problems including no-start conditions, fuel pump relay sticking, headlights and taillights failing, power window inoperability, and random activation of the horn and wipers. Water intrusion through a deteriorated windshield seal can accelerate TIPM failure.

Replace the TIPM assembly. Check the windshield seal for leaks that may allow water to drip onto the TIPM housing. TSB 08-036-07 covers TIPM diagnostic and replacement procedures. Aftermarket remanufactured TIPMs with upgraded components are available at lower cost than dealer units.

The front lower control arm bushings separate and deteriorate, causing a clunking noise over bumps and poor alignment stability. The lower ball joints also wear prematurely, leading to play in the front end and a wandering steering feel at highway speeds. Both issues develop progressively and worsen if not addressed promptly.

Replace the front lower control arms complete with bushings and ball joints as an assembly, since pressing in new bushings is often unsuccessful due to housing deformation. Perform a four-wheel alignment after replacement. Upgraded aftermarket control arms with improved bushing materials are available.

The 5-speed automatic (W5A580 or 545RFE depending on engine) develops torque converter shudder, delayed 1-2 upshifts, and harsh downshifts. The transmission solenoid pack degrades over time, causing erratic shift behavior and occasional limp-mode conditions. Overheating accelerates solenoid failure, especially during towing.

Replace the transmission solenoid pack and perform a complete fluid and filter change using ATF+4. If torque converter shudder is present, the torque converter should be replaced. TSB 21-008-07 addresses shift quality improvements through TCM software updates. Adding an auxiliary transmission cooler is recommended if the vehicle is used for towing.

The power steering pump develops a loud whining noise, especially during cold weather startup, and eventually begins leaking fluid from the pump shaft seal and reservoir. The whining noise intensifies when turning the steering wheel to full lock. Low fluid levels from leaks can cause pump cavitation and premature failure.

Replace the power steering pump and inspect the pressure and return lines for leaks at the crimp fittings. Use only Mopar ATF+4 or approved power steering fluid. TSB 19-008-07 addresses power steering pump noise on Chrysler LX-platform vehicles. Flush the entire system when replacing the pump to remove metal contamination.

The 5.7L Hemi V8-equipped Magnum is notorious for broken exhaust manifold bolts, especially on the driver's side (left bank). The bolts break due to repeated heat cycling, causing a ticking exhaust leak that is loudest on cold starts and diminishes as the engine warms. The broken studs in aluminum heads make extraction challenging.

Extract broken bolts using a reverse-threaded easy-out or by drilling and tapping for a new bolt. Replace all exhaust manifold bolts with updated Mopar studs and new exhaust manifold gaskets. Apply high-temperature anti-seize to the new fasteners. TSB 21-011-07 provides the revised bolt kit part number.

Chrysler (FCA US LLC) expanded the affected population to include 73,712 2005-2009 RAM 2500 trucks produced at the St. Louis North Assembly Plant. With this change, Chrysler is recalling certain model year 2004-2008 RAM 1500, 2005-2009 RAM 2500, 2006-2009 RAM 3500, 2007-2010 RAM 3500 Cab Chassis, 2008-2010 RAM 4500 and 5500 Cab Chassis, 2004-2009 Dodge Durango, 2007-2009 Chrysler Aspen, 2007-2012 Jeep Wrangler, 2008-2012 Dodge Challenger, 2005-2008 Dodge Magnum, 2005-2012 Chrysler 300, 2006-2012 Dodge Charger, 2005-2011 Dodge Dakota, and 2006-2009 Mitsubishi Raider vehicles originally sold, or ever registered, in AL, CA, FL, GA, HI, LA, MS, SC, TX, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands, or "Zone A." Additionally, unless included in "Zone A" above, Chrysler is also recalling 2004-2008 RAM 1500, 2005-2009 RAM 2500, 2006-2009 RAM 3500, 2007-2009 RAM 3500 Cab Chassis, 2008-2009 RAM 4500 and 5500 Cab Chassis, 2004-2009 Dodge Durango, 2007-2009 Chrysler Aspen, 2007-2009 Jeep Wrangler, 2008-2009 Dodge Challenger, 2005-2008 Dodge Magnum, 2005-2009 Chrysler 300, 2006-2009 Dodge Charger, 2005-2009 Dodge Dakota and 2006-2009 Mitsubishi Raider vehicles originally sold, or ever registered, in AZ, AR, DE, Washington D.C., IL, IN, KS, KY, MD, MO, NE, NV, NJ, NM, NC, OH, OK, PA, TN, VA, and WV, or "Zone B." Lastly, unless included in "Zone A" or "Zone B" above, Chrysler is recalling certain 2005-2008 RAM 2500, 2006-2008 RAM 3500, 2007-2008 RAM 3500 Cab Chassis, 2008 RAM 4500 and 5500 Cab Chassis, 2004-2008 Dodge Durango, 2007-2008 Chrysler Aspen, 2007-2008 Jeep Wrangler, 2008 Dodge Challenger, 2005-2008 Dodge Magnum, 2005-2008 Chrysler 300, 2006-2008 Dodge Charger, 2005-2008 Dodge Dakota, and 2006-2008 Mitsubishi Raider vehicles originally sold, or registered, in AK, CO, CT, ID, IA, ME, MA, MI, MN, MT, NH, NY, ND, OR, RI, SD, UT, VT, WA, WI, and WY.

These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment. These inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling. An inflator rupture may result in metal fragments striking the vehicle occupants resulting in serious injury or death.

Owners are advised not to drive their vehicle until the recall repair is complete. Chrysler will notify the Chrysler, Dodge, Jeep and RAM owners. Mitsubishi owners will be notified by their company. Dealers will replace the passenger frontal air bag inflator, free of charge. The recall began on March 27, 2017. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is S43. Note: This recall supersedes recall 14V-7700.

Chrysler (FCA US LLC) is recalling certain model year 2005-2009 Dodge Ram 2500, 2004-2008 Dodge Ram 1500 and Durango, 2006-2009 Dodge Ram 3500, 2008-2010 Dodge Ram 4500 and 5500, 2007-2008 Chrysler Aspen, 2005-2010 Chrysler 300, 300C, 300S, and SRT8, 2006-2010 Dodge Charger, 2005-2008 Magnum, 2005-2011 Dodge Dakota, and 2006-2009 Mitsubishi Raider vehicles. The affected vehicles are equipped with a dual-stage driver frontal air bag that may be susceptible to moisture intrusion which, over time, could cause the inflator to rupture.

In the event of a crash necessitating deployment of the driver's frontal air bag, the inflator could rupture with metal fragments striking the driver or other occupants resulting in serious injury or death.

Owners are advised not to drive their vehicle until the recall repair is complete. Chrysler will notify the affected Chrysler and Dodge owners and Mitsubishi will notify the affected Raider owners. Dealers will replace the driver's frontal air bag inflator, free of charge. The recall began for Chrylser on June 8, 2015. The recall for Mitsubishi started on June 24, 2015. Chrysler and Dodge owners may contact Chrysler customer service at 1-800-853-1403. Mitsubishi owners may call 1-888-648-7820. Chrysler's number for this recall is R25. Note: This recall supersedes recall 14V817 in its entirety. Vehicles that have had their driver side frontal air bag replaced previously need to have their air bag replaced under this recall as well.

CHRYSLER IS RECALLING 20,283 MY 2006-2009 CHARGER AND MAGNUM VEHICLES BUILT WITH THE POLICE PACKAGE AND EQUIPPED WITH A COLUMN SHIFTER. THE GEARSHIFT CABLE MAY BECOME DISENGAGED FROM THE STEERING COLUMN MOUNTING BRACKET AND CAUSE AN INCORRECT TRANSMISSION GEARSHIFT POSITION DISPLAY.

THIS COULD ALLOW THE VEHICLE TO MOVE IN AN UNEXPECTED DIRECTION STARTLING THE DRIVER, AND CAUSE A CRASH WITHOUT WARNING.

DEALERS WILL ADD A REDUNDANT LOCKING MECHANISM TO THE GEARSHIFT CABLE AT THE MOUNTING BRACKET TO ENSURE PROPER RETENTION AND SHIFT LINKAGE FUNCTION. THE RECALL BEGAN ON NOVEMBER 10, 2008. OWNERS MAY CONTACT CHRYSLER AT 1-800-853-1403.

CERTAIN PASSENGER VEHICLES EQUIPPED WITH 2.7 LITER ENGINES AND MK25E BRAKING SYSTEMS MAY EXHIBIT INADEQUATE CLEARANCE BETWEEN THE REAR BRAKE TUBES AND THE EXHAUST GAS RECIRCULATION TUBE. CONTACT BETWEEN THE BRAKE TUBES AND EXHAUST GAS RECIRCULATION TUBE OVER AN EXTENDED PERIOD OF TIME MAY CAUSE THE BRAKE TUBES TO WEAR THROUGH AND CAUSE A BRAKE FLUID LEAK.

THIS CAN RESULT IN A DECREASE OF BRAKING FORCE AND THE POTENTIAL FOR AN ENGINE COMPARTMENT FIRE.

DEALERS WILL INSPECT THE REAR BRAKE TUBES FOR DAMAGE AND REPLACE THEM FREE OF CHARGE. A CLIP WILL ALSO BE INSTALLED TO SECURE THE BRAKE TUBES TO THE RIGHT FRONT SHOCK TOWER TO MAINTAIN PROPER CLEARANCE TO THE EXHAUST GAS RECIRCULATION TUBE. THE RECALL BEGAN ON JUNE 26, 2006. OWNERS MAY CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.

ON CERTAIN PICKUP TRUCKS, SPORT UTILITY AND PASSENGER VEHICLES EQUIPPED WITH 42RLE AUTOMATIC TRANSMISSIONS, THE CUP PLUG THAT RETAINS THE PARK PAWL ANCHOR SHAFT MAY BE IMPROPERLY INSTALLED. IF THE SHAFT MOVES OUT OF POSITION, THE VEHICLE MAY NOT BE ABLE TO ACHIEVE 'PARK' POSITION.

IF THIS OCCURS AND THE PARKING BRAKE IS NOT APPLIED, THE VEHICLE MAY ROLL AWAY AND CAUSE A CRASH WITHOUT WARNING.

DEALERS WILL INSPECT THE TRANSMISSIONS AND INSTALL A BRACKET TO ENSURE THE PARK PAWL ANCHOR SHAFT IS RETAINED IN THE PROPER POSITION. THE RECALL BEGAN ON NOVEMBER 28, 2005. OWNERS MAY CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.