2006 Nissan Quest
Vehicle Specs & Maintenance Data
The 2006 Nissan Quest maintenance specs on this page cover the key fluids, torque values, and wear items you need for routine service. Use these numbers as a quick reference when performing oil changes, tire rotations, brake jobs, and other scheduled maintenance on your Nissan Quest.
For oil changes, the 2006 Nissan Quest takes 5W-30 Full Synthetic motor oil with a capacity of 4.6 quarts. Brake fluid type is DOT 3, the recommended coolant is Blue Long Life Coolant (OAT), and transmission fluid is Nissan Matic S. Always use the manufacturer-recommended fluids to maintain warranty coverage and engine longevity.
When mounting wheels on the Nissan Quest, torque the lug nuts to 83 ft-lbs using a calibrated torque wrench. Over- or under-torquing can lead to warped brake rotors or loose wheels. Re-torque after 50 to 100 miles on newly installed wheels.
There is 1 NHTSA safety recall on file for the 2006 Nissan Quest. Check the Recalls tab below for full details.
Specifications on this page are compiled from multiple publicly available sources including manufacturer documentation, NHTSA data, and automotive databases. Always cross-reference with your owner's manual or official factory documentation before purchasing parts or performing any service.
The 2006 Nissan Quest uses 5W-30 Full Synthetic motor oil (4.6 qt capacity), requires lug nuts torqued to 83 ft-lbs, takes DOT 3 brake fluid.
Enter a diagnostic trouble code to see causes, symptoms, and fixes for the 2006 Nissan Quest.
No known problems reported for this vehicle yet.
1 NHTSA safety recall for the 2006 Nissan Quest. Check your VIN at NHTSA.gov
SEATS:MID/REAR ASSEMBLY
ON CERTAIN MINI VANS, THERE IS A SEAT ADJUSTMENT MECHANISM THAT CONTAINS EXPOSED MOVING COMPONENTS LOCATED AT THE REAR INSIDE EDGE OF THE SECOND ROW SEAT.
WHEN THE OPERATOR ATTEMPTS SEAT ADJUSTMENT, A FINGER MAY BE PINCHED IN THE MOVING SEAT ADJUSTMENT MECHANISM WHICH COULD CAUSE AN INJURY.
ON EARLIER MODEL VEHICLES BUILT THROUGH JUNE 28, 2004, DEALERS WILL REPLACE THE INBOARD SECOND ROW SEAT ADJUSTMENT HANDLE, RIVET A PLASTIC REINFORCEMENT TO BACKSIDE OF THE EXISTING SEAT BACK COVER CARPETING, INSTALL TIE-DOWNS AND A FLANGE TO THE INBOARD SIDE SHIELD. ON VEHICLES PRODUCED FROM JUNE 29, 2004 THROUGH SEPTEMBER 26, 2005, DEALERS WILL RIVET A PLASTIC REINFORCEMENT TO THE BACKSIDE OF THE EXISTING SEAT BACK COVER CARPETING, INSTALL TIE-DOWNS AND A FLANGE ON THE INBOARD SIDE SHIELD. THE RECALL BEGAN ON DECEMBER 19, 2005. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.